The system’s bearing structure is in polypropylene and guarantees the highest safety standards in the event of failure of the due2 porcelain stoneware tiles, with no further reinforcement systems required.

It is a simple, high-performing structure, quick to install and high-strength, which permits the creation of raised paving with a large number of tile sizes and layouts. The D Plain system has been developed for the outdoor installation of porcelain stoneware raised paving and offers architects versatile solutions with the greatest compositional freedom. Finally, to complete installation, fill the joints with very fine sand (diameter 0-3 mm) or a mixture of fine sand and polymers. A rubber hammer can be used to correct any slight differences in level. Cross-shaped spacers of the type used in conventional tile installation can be used when laying the porcelain stoneware. The due2 tiles can now be installed dry, leaving joints of at least 2 mm. A slope of ≥ 1% should be left to ensure that water drains off the paving check the flatness of the surface with a straightedge. After this, add and then compact first a layer of aggregate or gravel (diameter 4-8 mm) and then add and compact a layer of fine gravel (diameter 2-5 mm) to facilitate levelling of the surface. Otherwise add a layer of non-woven fabric.

Compact the bottom of the hole and make sure that it slopes slightly (≥ 2%) to prevent standing water. In this case, the substrate has to be dug out to a depth of at least 10 cm in dry climates and on well drained ground, or deeper in cold or rainy climates. Due2 porcelain stoneware tiles can be installed on gravel on large surfaces, and for installations with narrow joints or without grass between tiles.

Instal the new Dig Out!